Snap-on Panels have been designed for use in roofing, mansard and fascia applications. Snap-on Panels are designed to be installed over a waterproofed solid substrate and a minimum 3:12 roof pitch. Snap-on Panels are to be factory roll formed in continuous lengths (minimum panel length is 4 feet). These panels are ideal for specification on applications where roof transitions are required. The simplicity of the pan design combined with in-line tension leveling provides superior flatness and allows for greater workability on site. UL 90 RatingSteel Snap-on Standing Seam and High Seam Panels carry a UL 90 rating for wind uplift when fastened to an underlayment assembly including 5/8" plywood or OSB (oriented strand board) laminated to rigid insulation (UL Construction No. 351 & 352). This is one of the few UL 90 Systems that does not require sealant between plywood boards. For further details contact Petersen Aluminum Corporation. Air and Water InfiltrationPetersen Snap-on Panels meet the full performance requirements of the ASTM E 283 air infiltration test and the ASTM E 331 water penetration test when applied over a solid substrate. For complete test results, contact Petersen Aluminum Corporation. Materialsa) 24 ga. G-90 hot-dipped galvanized steel b) .032 3105-H14 aluminum |
TrimAll flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.080 gauge as specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year, non-prorated warranty shall be supplied covering finish performance. Curved PanelsThe 1" High Snap-on Standing Seam Panel can now be curved to a concave or convex radius, with a minimum radius of 9 ft. This panel is ideal for barrel vaults and entranceways. Curved panels must be installed over a waterproofed solid substrate. InstallationPAC-CLAD Snap-on Panels shall be installed over solid decking (5/8" plywood, nailboard insulation or equal) with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen Non-Penetrating Clips, fastening on 18" centers (max.). Minimum slope at 3:12 pitch. Consult a local architect or engineer for requirements of local codes and conditions. |
|||||||||||||||||||||||||
|
||||||||||||||||||||||||||
Braxton╒s Animal Works
Wayne, PA |
||||||||||||||||||||||||||
|
||||||||||||||||||||||||||
Top Photo: Bottom Photo: |
||||||||||||||||||||||||||